Installing an Aqua Rock™
Fountain Kit
In the Ground 10 Easy Steps
Step 1.
Choose a spot
for the Fountain
Step 2.
Clear an area
Step 3.
Dig a hole for the
bucket
Step 4.
Put the bucket in
the hole
Step 5.
Place pump in bucket
and lid on bucket
Step 6.
Position plastic
liner over bucket
Step
7. Cover plastic
liner with decorative stone
Step
8. Put tube into the
bottom of rock
Step
9. Add water until
bucket is full
Step
10. Plug in pump and
enjoy the bubbling water
Installing an Aqua Rock™
Fountain Kit
In a Pot 5 Easy Steps
Diagram
Ideal for indoor or patio
use.
Items
Needed: 1) An
Aqua RockTM Fountain Kit 2) A water proof pot with an
opening of 20 in. or more and a height of 16 in. or
more.
3) Drill with a 1/4
in. bit and a 1-1/4 in. bit. 4) Duct Tape 5) Gravel 6) Plants
Step
1 Drill about
thirteen 1/4 in. holes around the bottom of the five gallon bucket.
Space the holes about 3 in. apart. This will allow water to fill the
bucket from the bottom.
Step
2 Drill a 1-1/4
in. hole at the top of the pot. This is for the pump’s cord to go
through, or you can drape the cord over the side of the pot. Don’t let
the water level in the pot reach this hole.
Step
3 Put the pump in
the bucket and the bucket in the pot. Run the hose and cord out the lid
of the bucket. Put the cord through the hole in the pot. Duct tape the hole on the lid and the hole on the pot so that no
gravel can pass through the holes.
Step
4 Fill the pot
with decorative gravel. Make sure to clean the gravel of dirt.
Step
5 Put plants in
the gravel for decoration. Keep them in their pots and bury the pots in
the gravel. Slide the rock onto the tube. Fill the pot with water
and plug in.
We are a supplier of Mulch, Soils, Gravel,
Firewood, Water Ponds, bricks for pavers and retaining walls. Our primary
delivery areas include Marengo, Crystal Lake, Lake in the Hills, Algonquin,
Huntley, Dundee, Hampshire, Genoa, Sycamore, Elgin, South Elgin, Elburn,
Gilberts, Pingree Grove,Wasco, St. Charles, Burlington, Plato Center, Lily
Lake.